30W Din Rail Industrial PoE

30W Din Rail Industrial PoE Injector


Can be connected to APs, IP cameras and other Ethernet end terminals

Buy Now


Over Power Protection, Short Circuit Protection
Protection Type: Auto-Recovery

Over Voltage
<60V@24Vdc / 54Vdc at full load
Protection Type: Latch(Re-Start)

Over Temperature
90°C± 5°C
Protection Type: Auto-Recovery

Environmental & Physical

Operation Temperature

Working Humidity
5%~90% RH Non-Condensing

Storage Temp., Humidity
-40°C~85°C, 5%~95% RH

Temp. Coefficient
±0.03%/°C (0°C~50°C)

Dielectric Withstanding Voltage
I/P-O/P: 1.5KVac, I/P-FG: 1.5KVac


400,000 hrs min SR332 (25°C)

100mm x 31mm x 140mm (Lx Wx H)


DC Connector
6-Contact Terminal Block

Data In/ PoE Out
RJ45 Shielded Socket


Note: All parameters NOT specially mentioned are measured at 24Vdc/54Vdc input, rated load and 25℃ of ambient temperature. Ripple current is measured at 20MHz of bandwidth. The measured terminal is paralleled with a 47uF E-cap and a 0.1uF Ceramic cap.

Product Highlights
PIR030-24-GS-B is a single port PoE injector that complies with IEEE802.3 at/af and provides maximum 30W power over CAT5 or 5e UTP/STP Ethernet cable by two pairs. It also supports two redundant DC input from 20Vdc~60Vdc for industrial backup. The device can be connected to Ethernet-powered devices, such as wireless APs, IP cameras, and other Ethernet end terminals that allow delivering and operating both data and power over an Ethernet cable in an industrial environment from -40 to 75°C under any severe condition.
  • 54V, 30 Watts of High Power-over-Ethernet
  • IEEE802.3af/at compliant (Only for PIR030-24-GS-B)
  • Support 10/100/1000Mbps for PoE OUT and DATA IN
  • Two DC Input for power redundancy with range from 20Vdc~60Vdc
  • Industrial rated IP30
  • -40 to 75°C operating temperature range
  • Din-rail and Wall mount