Industrial PoE Injector

75W Din Rail Industrial PoE Injector


Can be connected to APs, IP cameras and other Ethernet end terminals

Buy Now


Over Power Protection, Short Circuit Protection
Protection Type: Auto-Recovery

Over Voltage
<60V@24Vdc / 54Vdc at full load
Protection Type: Latch(Re-Start)

Over Temperature
90°C± 5°C
Protection Type: Auto-Recovery

Environmental & Physical

Operation Temperature

Working Humidity
5%~90% RH Non-Condensing

Storage Temp., Humidity
-40°C~85°C, 5%~95% RH

Temp. Coefficient
±0.03%/°C (0°C~50°C)

Dielectric Withstanding Voltage
I/P-O/P: 1.5KVac, I/P-FG: 1.5KVac


400,000 hrs min SR332 (25°C)

100mm x 31mm x 140mm (Lx Wx H)


DC Connector
6-Contact Terminal Block

Data In/ PoE Out
RJ45 Shielded Socket


Note: All parameters NOT specially mentioned are measured at 24Vdc/54Vdc input, rated load and 25℃ of ambient temperature. Ripple current is measured at 20MHz of bandwidth. The measured terminal is paralleled with a 47uF E-cap and a 0.1uF Ceramic cap.

Product Highlights
PIR075-24-GP-B is a single port passive PoE injector which provides maximum 75W power over CAT5 or 5e UTP/STP Ethernet cable by four pairs. It also supports two redundant DC inputs from 20Vdc~60- Vdc for industrial backup. The device can be connected to Ethernet powered devices, such as wireless LAN high power devices, pan-tilt- zoom (PTZ), speed dome cameras, IP videophones, and other high power Ethernet end terminals that allow delivering and operating both data and power with a proprietary 54V-compatible device over an Ethernet cable in industrial environment from -40 to 75°C under any severe condition.
  • 54V, 75 Watts of High Power-over-Ethernet
  • IEEE802.3af/at compliant (Only for PIR030-24-GS-B)
  • Support 10/100/1000Mbps for PoE OUT and DATA IN
  • Two DC Input for power redundancy with range from 20Vdc~60Vdc
  • Industrial rated IP30
  • -40 to 75°C operating temperature range
  • Din-rail and Wall mount